Question about Washing Machines
...cold water supply valve can be bad, the cold water hose can be twisted and crimped, the selector switch for cold can be not operating or the water inlet filter < on washer end of hose can be plugged, ...
...and cold supply it only uses the cold supply. How can I change it to use the hot also? The machine only uses the cold supply on low temperature washes. For washes at 60 and 95C the hot supply is
cold supply needed No. But if you are only going to use cold supply you will need a adapter to make the hose connections to the back of the machine as both valves will be needed. The machine will have
...cold tap supply (single end) and the hot and cold feed pipes connected to the washer screw onto the other two ends. The machine will now be fooled into thinking it has two separate feeds! The machine ...
...supply only cold water or does it supply water to somewhere else? supplies hot water when needed, cold water when needed. and then warm water when needed. so the second coil is for warm water. it ...
cold supply, but you do not have a hot supply convenient, you will need to purchase, from a hardware (?) store, a 'Y' adapter. Upside down the single end (internal thread) screws into the cold
...supply to both hot and cold water inlets. Are they both required or can I cap one and supply cold only to the cold input? I think only cold water is enough. The washer machine will warm up the
Question about Nexxt 700 Series WFMC6401UC Front Load Washer
...cold supply does not dispense into detergent tray I've checked the inlet water strainer on the supply side of the cold water and it looked clean but I still cleaned it. I've replaced the supply hose ...
Question about Nexxt 700 Series WFMC6401UC Front Load Washer
...me hot and cold if you only have a cold supply hose then you can cheaply buy a Y piece connector that would Split the cold supply into the two feed hoses onto one cold supply pipe, Hope this
Question about Nexxt 700 Series WFMC6401UC Front Load Washer
got the hoses connected correctly hot to hot supply , cold hose to cold mains supply if its cold supply only to machine , make sure it's not connected to hot water supply, this could be worth checking
Usually answered in minutes!
350 Questions
260 Questions
250 Questions
168 Questions
217 Questions