Questions & Answers for: Sym cold starting

Question about 2004 Husky 125

1 Answer

starting_when_cold_runs_rough_idle Will this also solve my problem? I tried adjusting the idle speed a little bit, but then it runs fast when the engine is hot enough. I've adjusted the air adjustment

Ad

Question about 2004 Husky 125

1 Answer

starting_when_cold_runs_rough_idle Will this also solve my problem? I tried adjusting the idle speed a little bit, but then it runs fast when the engine is hot enough. I've adjusted the air adjustment

Ad

sportster 1000 cuts out and dies when cold. Hard to start and keep running. If I do get it going it and warmed up it runs fine after about 10 minutes. sounds like faulty choke. if it is electronic ...

Question about 2004 Husky 125

1 Answer

...cold wheather the oil is thick and will make starting sluggish, or not at all. it takes alot of cold cranking amps to start a cold motor. you could probably jump start it with a battery charger that ...

Question about 2004 Husky 125

2 Answers

...starting it every week or so is taking more battery power out to start then you are putting back in running it a few minutes (10) because of the cold temperatures. This will drain the battery making ...

Question about 1999 Husky 125

1 Answer

...is no good. How old is the battery? did you take it out and store it inside if you live where its cold? Battery's no good if it

How do u test auto by starter component? My scooter wont idle especially when cold. It starts up normal and idles high for about 20 seconds and then drops to low idle and dies. I pulled the auto by ...

Question about 2011 Maxsym 400i

2 Answers

maxsym start I cannot start the engine when vehicle is cold. Takes like 6,7 seconds to start and then it stops if u dont accelerate immediately. I have it only 2 weeks. It should be under warranty. ...

Question about 2011 Maxsym 400i

1 Answer

NOT STARTING WHEN COLD HI IV GOT 04 SUM JET EURO X 50 AND IT DOES NOT STRAT FROM COLD Need to adjust the spark plug gap/change and also push Air screw 1/2 thread inside in the carburator

...starting then cutting out for about ten minutes then when warm it runs fine I have replaced the carb this has not made any difference please help Have also tried the carb heater that's no good ether ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Sym Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Brad Brown

Level 3 Expert

19187 Answers

NOEL
NOEL

Level 3 Expert

8606 Answers

Are you a Sym Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...