Questions & Answers for: coil elements

...would not heat. We tested the lower element and it is not broken. The problem appears to be a "coil" on the circuit board that sends current to the lower element. Question: Can the "coil" piece ...

Coils freeze up,refridgerator and freezer stops working Coils freeze up in freezer then freezer and fridge stop cooling. I defrosted the freezer and made sure the drain tube was thawed. Both the ...

...elements metal is very britlle.it is you have to replace the entire eye to fix it. the coil most likely had a very gap in the break and acted like a short making and breaking connection until the gap ...

...elements. Every 6 -8 hours the timer will go into defrost and melt any ice build up on the evaporator coil. Without the heating element the coil will freeze up and the cooling will not be

Heating element. How about just replacing the coil? Hi folks ~ My heating element coil broke. Is there just a coil available out there? It seems silly to replace the whole element when it's clearly ...

...of the element of which turbochef has taken care of. COMPONENTS IR Element The IR element - a dual coil type heater - is located in the bottom of the oven cavity. The first coil is the heating coil. ...

coil elements are warping out of the coil supports Range coil elements are warping out of the support bars on the coils and tilting so that the pots are not level. I have never had this happen on any ...

...WOULD IT NOT BE HEATING UP This means your heating element has burnt out. Usually they consist of a coil, much like you can see on a hair dryer, in line with the air intake. Most common cause is the ...

...coil is getting 24 volts and the elements are not heating, then one of the following issues is going on. 1. The sequencer contacts are not closing because it is defective. Therefore the heating ...

...is not getting OK to come on, or your Contactor is Bad. Is there proper voltage at heater Contactor Coil? There will be a label on the side to indicate Coil Voltage. If proper voltage at coil and no ...