Questions & Answers for: kawasaki VN 1500 Vulcan Classic clutch bleeding

Question about 2004 VN 1500 Vulcan Classic

1 Answer

...clutch to begin with and slips....bleeding helps...but only temperary....any suggestions? if the bleeding temporarily helps you may have a bad master or slave cylinder, check the system really good ...

Ad

Question about 1996 VN 1500 Vulcan Classic

1 Answer

where is the bleeder for Vulcan 1500 clutch? where is the bleeder valve for 1996 Vulcan Classic-A 1500 clutch? It is under the left engin cover. You have to remove the shifter and the footpeg or ...

Ad

Question about 1996 VN 1500 Vulcan Classic

2 Answers

clutch slippage The clutch keeps changing,at times it works fine other times it slips when starting out other times it'll stall the bike when starting to release clutch handle.At times it'll slip on ...

Question about 1997 VN 1500 Vulcan Classic

1 Answer

bleeding clutch tryd bleeding the clutch and now there dosent feel like any thing is thwer whn i sqeeze it. The best success I have bleeding my clutch is to do it in this order. 1- fill reservoir with

Question about 1997 VN 1500 Vulcan Classic

1 Answer

...clutch lever. Remove the cap and I think you will see there is little or no fluid in the reservoir. You need to fill it up then bleed the system to remove air in the line. This is done the same a ...

Question about 2004 VN 1500 Vulcan Classic

1 Answer

bleeding the clutch system, make sure the fluid reservoir is full and tighten the screws on the cover. Do not apply too much force when tightening these screws as they have a tendency to strip. If you

Question about 1996 VN 1500 Vulcan Classic

1 Answer

...clutch lever while bleeding.To do this )1 - remove all fluid from the fluid reservoir. 2) Fill with fresh fluid and replace the cap LOOSELY, you just want to cover the reservoir from any contaminants ...

Question about 1996 VN 1500 Vulcan Classic

0 Answer

No clutch pressure at handle on 96 Kawasaki 1500. drained fluid at reservoir cleaned and refilled with Dot 4. Fluid is clear and still nothing. I do not know hot to bleed system (may be air in system)

Question about 1996 VN 1500 Vulcan Classic

1 Answer

...clutch lever, should fix if not repeat bleeding until you have good pressure on clutch lever, dont let fluild get to low . once pressure is good refill and put cap back on. put bike back togather and ...

Question about 2004 VN 1500 Vulcan Classic

1 Answer

bleed wet clutch undo the bleed nipple slightly on the slave cylinder , remove cover on clutch lever and make sure to keep it topped up as you bleed ! pull lever and hold as you nip up the nipple then

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...