...bleeder screw at the top of the trans, and bleed the clutch as you would the regular brake system, but never pump the pedal, tighten screw, with foot off of clutch pedal open screw and press pedal to ...
...Clutch Cylinder. What Steps do I take? I am most concerned with Bleeding the Lines After the New part is installed..... You need to bench bleed the master cylinder. You can gently clamp it in a vise ...
...clutch line. Loosen the bleeder screw, and put a two or three foot vacuum line on it. Submerse the other end of the line in a bottle of brake fluid. Pump the clutch untill no more bubbles are coming ...
...clutch slave bleeder valve a little until drips. Let somebody push the clutch pedal. You will observe the clutch fluid flow initially with bubbles. Stop pushing the clutch pedal upon observing solid ...
Where is the bleeder for the hydraulic clutch? it should be on the slave cylinder.
...clutch pedal with the bleeder open or you will **** air in. After the bleeder is closed, pull the pedal back to the top and repeat until there is no more air coming from the bleeder. Be sure to check ...
Question about 2000 Focus
bleeder screw while someone pumps and holds the clutch pedal, several times, or until no air comes out, remember to keep fluid resevoir full while bleeding. scott's answer is "jumping the gun" sort of
Usually answered in minutes!
3,749 Questions
2,612 Questions
2,055 Questions
1,226 Questions
897 Questions