Questions & Answers for: Whirlpool clue suspect

clue. ck left hinge screws lid switch is under left rear and is tough to acess if switch seems suspect 2 screws in rear of console are removed and console rolled back to acess switch also ckd wires to

...don't seem to touch the sensor and hold of the timer, so clothes consistently come out damp. Any clues, gurus? You are having problems with your operating thermostat . Here is a link for part it

...suspect it is bad you can check it with a meter. That leg of the timer should have continuity with other terminals on the timer at different spots on the timer. Turning the timer and checking for ...

...suspect it is bad you can check it with a meter. That leg of the timer should have continuity with other terminals on the timer at different spots on the timer. Turning the timer and checking for ...

...suspect it is bad you can check it with a meter. That leg of the timer should have continuity with other terminals on the timer at different spots on the timer. Turning the timer and checking for ...

clue. That would tell me the relay is stuck in start mode causing the compressor to get hot and quit. I would remove the relay and put my HS410 start pack to see if the compressor comes on and I would

...suspect it is bad you can check it with a meter. That leg of the timer should have continuity with other terminals on the timer at different spots on the timer. Turning the timer and checking for ...

...clue as to what part number to ask for. Any help would be appreciated. The burn smell is from the belt slipping and so you can remove the belt using tips from the link at the bottom of the solution. ...

clue is the COLD side. If you are on a well, sand, sediment, debris, is NOTORIOUS for clogging up the inlet cold water screen. Turn off the cold water. Get a towel to place underneath the cold hose as