...tape has been removed from the contacts on the ink cartridge. Replace the cartridges. Snap the lids closed. Close the printer's front cover. When prompted on the printer's LCD to choose New or Old, ...
...close do you have the striker plate missing? if not i had spryed some WD-40 on my and it worked. if you have striker plate missing try to put some tape,(electrical tape). you can find these parts at ...
...tape the bottom row of horizontal contact The cartridge off Insert the cartridge into the printer and close the lid. The printer will now on the move, but wait until there on the screen Your computer ...
Question about LabelMANAGER 210D - Labelmaker - B/W - thermal transfer - Roll - 180 dpi Printer
...lid to the tape door. There is a small bar in the lid. The slot on the tool slides over the bar in the lid. The soft yellow pad should push down on the tape when the lid is closed. It is a cleaning ...
Question about Hewlett Packard Deskjet 5650 InkJet Printer
...tape. 9. Reinstall cartridge and close lid. Printer will now recalibrate. Once the process is complete the ink level meter should be reading full again. I hope this helps, if so please rate our ...
Question about Hewlett Packard Deskjet 5650 InkJet Printer
...tape. 9. Reinstall cartridge and close lid. Printer will now recalibrate. Once the process is complete the ink level meter should be reading full again. Doesn't always work, but you can try. Here are ...
...carrier and close the lid. 5. Remove the tape from the color print cartridge, insert it in the right cartridge carrier and close the lid. 6. Close the printer. Your ink cartridges are
...closed when the lid closes...perhaps broken. If that is the case, you can just tape it closed or get a new part that makescloses it properly. Could be a bad motor winding for the high speed
Question about X6575 All-In-One InkJet Printer
...close the lid from some reason then adjust the light switch in the boot so as not work until you get the lid fixed or simply pull the power wire from the switch and tape it up or last resort remove ...
...tape, and keep the moving piece in place, to finally close the lid. Tried to print and there was a knocking. Canceled the print cycle, readjusted the tape, and tried again. It worked with no knocking ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions
