Questions & Answers for: close hopper door

...push the toner hopper door FULLY closed, at the very end, you will press on the two thumb tabs on the hopper door and the cartridge will "pop up" for removal. Good luck & let me know how it

...out to open the correct toner that is low. Opent the door and install the new toner bottle and remove the emptied toner bottle and push the hopper back into place and close the front doors. Good ...

install. put toner hopper back in. close all covers and turn on machine. On the Lemark E232 , where do I find the buttons to reset the the photoconductor. It still had 11 pages to print on the old one

...pull out the toner bottle, give it 1 or 2 gentle shakes, and put it back in the hopper. Then push the hopper closed until it snaps into place, push the handle back down, and close the front

...the plastic guide. - Reinstall the toner hopper. - Close the right side door and front door. If the machine was on when you replaced the photoconductor, it should automatically detect the new

...close the doors and check. You have to drop the blue lever to the down position then place the sealed cartridge face down on top of the toner hopper you have just pulled out by the blue handle. The ...

...hopper error code.... Try to take the toner bottle out and close the toner door and turn the Main power switch OFF. Turn the copier back ON and let the copier come back to Ready and install the toner ...

...theres a connector beneath the PCU,pull it then pull out the PCU,use the same same procedure to put it in,start with the PCU,return the connector and put in the hopper,then close all ...

...hopper door switch is not locking into place (maybe worn through use) making the machine think that the hopper isn't closed. 2 options, re-align switch closer to the hopper so as to engage when it's ...

My gaggia accademia says front panel that the hopper lid needs closed. The lid is closed where the beans go in the hopper. I don't see any other doors to close. Any ideas? Lid position sensor failure