...clear codes on my 91 4WD Subaru Legacy Station Wagon. I only have a Chilton 1985-96 Subaru Manuel. It doesn't show where or how to get the codes to display. I need Diagrams of where the connector is ...
...out there is the actron mini. All it does is read codes, give you the code number, give you the readiness status, and allows you to clear stored codes. It goes for $80. and most part stores carry
2000 Subaru legacy outback 2.5L DTC P0420 code will not clear. I replaced the rear O2 sensor and the CEL is still on. I used the scan tool to clear the code but it will not clear. that code is saying ...
...store. There they may have a code identifier that will isolate and reveal the code they can also clear the code. If that fails then disconnect ans reconnect the battery to clear the code. If there ...
how to clear codes when problem is fixed codes will clear themselfs if problem isnt fixed codes will come right back
...be much appreciated! Thank you Yes that is right: Current trouble codes shown on the display are cleared by turning the ignition switch OFF after conducting self-diagnosis operation. Previous ...
...clear the codes, and if the light is still on all that means is that you just made room for another code to show up. As long as you only have the one code, you'll be fine. But if you had 3 codes, ...
...codes. CLEAR MEMORY After eliminating problem as per trouble code, clear memory as follows: Make sure ignition switch is ON (and engine off). Connect one DIAG. terminal (1) on diagnosis connector (2) ...
...codes. CLEAR MEMORY After eliminating problem as per trouble code, clear memory as follows: Make sure ignition switch is ON (and engine off). Connect one DIAG. terminal (1) on diagnosis connector (2) ...
...negitive battery cable for a few seconds then reconnect the cable and start the car to see if it cleared the code. If not your car might need a code reader to clear the code or something else ...
Usually answered in minutes!
447 Questions
411 Questions
381 Questions
354 Questions
317 Questions