Questions & Answers for: Dodge clear code

code will clear itself when 40 warm up cycles have completed , or this code can be cleared using a scantool , if you don't have a scantool , option is stop by an autozone , ask if they can scan it and

code 442 cleared it now code 455 whats up code 442 book said small leak in evap.cleared code two days later code 455 book says large leak in evap. system there is a leak within the evap solenoid and ...

code is active it will not clear.Scan tool is recommended. I have in the past, removed both battery cables from the battery, then touch the cables together foe two minutes will clear codes. but if you

...clear the code. but if you dont figure out what set the code it will set the code again. Cars are outfitted with plenty of electrical system that monitors its working. When something goes wrong it ...

...clear the code after a series or diagnostic run cycles. If you determine that the CEL is on erroneously, it can be cleared with most OBD code readers. Also, use the code reader to determine what is ...

...clear the code or fix the problem. You can use a code scaner, or visit local AutoZone to decode and find the code explanation, for free. If you decide to clear the code, use the code scaner. You can ...

...clear a code I have a P 168.4 code. It is the only one that came up. How do I clear it? A lot of times a code can be cleared by simply disconnecting the negative battery cable for about ten ...

p0455 i have cleared the code and they have came back clearing the code does not fix the problem it only clears the code untill the computer registers that a certain component is faulty.fix the faulty

...code re-appear? No, it will not harm the engine and it is common practice among mechanics to clear codes and see if they re-appear. It may be helpful to write the codes down before you clear it for a ...

...senser https://www.cargurus.com/Cars/Discussion-t22054_ds572186 One way to clear code is removeing the ground cable from the battery for at least 5min then connect it and your codes should be