...metal blade (eg old knife) between sides of the panel to unclip it as you pull down. Rather fiddly and danger of splitting the plastic. However if you succeed you can then clean all the mildew away ...
...leaves dirty marks on fingers I have the same problem with my Nikon N65 film SLR and I bought a vintage Super 8 movie camera where the rubber had turned to the consistency of gum on ...
...clean any residue from the seal off,100% of it,if you leave any residue the new seal will not seal properly and it will leak,methanal or a strong isapropyl alcohol will work well for this and leaves ...
...clean and I lightly lubricate mine with white grease just to help things slide easier. In my research the motor and switch rarely go bad. It's the plastic and pot metal slides that break and need to ...
Question about Talea Giro Espresso Machine
...metal tab and align magnet on rear where this sits, at the same time then place small magnet where door tab hits plastic sensor in machine roof then power off and on machine resets to neutral remove ...
Question about MFC 240C All-In-One InkJet Printer
...clean the contacts on it as well. Replace the cartridge and turn the printer on. It should show the ink level and operate properly. in my case, a small plastic jumper on the roof of where the ink ...
...clean it of metal shavings/debris and to re-grease it. It is a very frustrating job and one that may wish to leave to the Mercedes experts because even having rebuilt the motor there is a real knack ...
leaves, etc comes down this tube, and gets stuck in the small rubber pcs at the bottom. You can either clean this pc out, or what was suggested to me, was to cut a small pc off the end, to allow
Question about 2003 New Beetle Convertible
...metal switch. You should be able to lift this up and down with your finger. Get some electrical grease and coat the switch as best you can. The problem is that a great deal of road grime accumulates ...
metal as a ground plane. As far as how far you can get out, that depends on how much power the radio puts out, and how clean your audio signal is. 1.4 swr is OK but it can be much better. If the power
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions