Questions & Answers for: Craftsman clean my carb

...clean the small portals in carb. Use a carb. cleaner while cleaning. Make sure the small screen in carb. is free of debris. The smallest of paticles can cause the carb. not to run right. Reassemble ...

Ad

Question about 25cc Gas Line Trimmer

1 Answer

carb. cleaner. Use a Den Tek brush, (used for cleaning between teeth), to clean the small portals. This works great for this job. Make sure the small screen in carb. is free of debris. Reassemble carb

Ad

Question about 25cc Gas Line Trimmer

1 Answer

carb and clean the fuel bowl and jets. use a jet carb cleaner to do this. without knowing what type of engine, make sure all ur jets are clean. use a fine wire to insure they are clean and put te carb

Question about 4 Cycle Blower/Vac

1 Answer

...clean the small portals in carb. Reassemble and start. (NOTE: If the cleaning doesn't work, then buy a carb. kit abd replace all appropriate parts.) If you need further assistance, just let me know. ...

Question about 4 Cycle Blower/Vac

1 Answer

...carb.there is a small screen in side.carefully take an air hose and blow it out.do not blow to hard or the screen will blow out.once it's clean the unit will start right up.hope this helped,let me ...

Question about 4 Cycle Blower/Vac

1 Answer

carb clean? If you want to clean it, remove the covers, gaskets and diaghrams (noting what went where) and spray liberally with non-flammable brake cleaner. Check the fine mesh screen in the fuel pump

Question about 25cc Gas Line Trimmer

1 Answer

...clean this part of the carb. regular carb spray cleaners are way too strong and can damage the sensitive parts in these carbs. Don't use any and dont ever soak it in carb cleaner. Only spray clean it ...

Question about 25cc Gas Line Trimmer

1 Answer

...Clean your carb and make sure your needle and seat are also clean and the screen inside carb at inlet of fuel, also the primer has a check valve inside it that gums up, try to spray carb clean or sea ...

...Carb was clean inside but cleaned carb thoroughly anyway,cleaned tank.runs very rough and only at med to low speed,dies if pushed to run any faster.Also, doesnt want to run with new air filter ...

...remove the bowel, the main jet and emulsion tube are screwed up inside the carb, remove and clean, you can purchase jet cleaning wires which will sort out the cleaning, you can also use carb

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Craftsman Garden Experts

john h

Level 3 Expert

29494 Answers

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Are you a Craftsman Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...