Questions & Answers for: how do you clean boot Cars & Trucks

...for a dirty earth lead in boot or similiar? Removed lock solenoid actuator and tested off vehicle, cleaned up terminals and pulled some fuses and relays cleaning wherever I thought necessary, also ...

...snap ring within the CV joint the nedds to be spread OPEN to release CV joint from axle, Once CV is cleaned and repacked with grease rintall onto axle by again spreading apart clamp. Prior to ...

...boot off and clean up the area free from grease. Then pull the axle all the way over to one side and remove the first ball...repeat this until you have all of the ball bearing out. The axle will now ...

...the switch for this i don't see a push button switch is it in the lock, can this be taken apart and cleaned by a novice? Thank you. just clean the contacts on the boot lid then the boot wih sand ...

...on and hook it in the spot and bend it forward then bend the tabs over that hold the clamp in place. Be sure where the boot fits it is clean or you will not get it tight enough and it will come

boot open is coming up on the display window check your boot connection at the rear or clean the boot sensor at the back on the boot lid

...the shaft, remove the entire unit and do it on the bench, put the shaft in a vise and knock the joint off with a soft headed hammer clean it repack it and install the boot with new grease, good ...

...boot replacement kit  remove axle from suspension and trans. clean old grease out of failed axle, stuff new grease into cv joint and put new boot on shaft close to joint. fill the boot with the ...

can't find miss, put in two sets of plugs in two weeks, cleaned boots from coils,checked injectors and cleaned the mass air sensor. no engine lights come on. I am stumped for now. can't ...

...boot. Then thoroughly clean the CV joint. Install the new boot. Install the cleaned joint. Install the new grease and use a special tool to install the bands that hold the boot in place. You don't ...