Questions & Answers for: Audi where does the clamp attach

boost leak on 225 tt i have a 225 tt coupe with an apr dv installed, recently when i hit the gas firmly there is a hissing sound until i let off the gas. I switched back to the stock dv with the same ...

...clamp on the brake piston and pushed it back as far as it will go but i need another 1/4 inch for it to fit on . any suggestions is there a special tool for it ?Thank you. If you have the pistons ...

From time to time the turbo hose attached to the throttle body falls off.Usually when the engine is hot. I own an Audi A4 1.8L 2004. Change he clamp. 

attach one to ground and the red one to "short" the curcuit. This is done by placing the red jumper cable clamp accross both non-grounded leads off the startrer selenoid. If you hear a click, then the

why is it blowing cold air all the time sometimes if i turn the power down it blows a little bit warm but not much Hi, it sounds like you flow is restricted, probably due to clogging of the heater ...

...Attach clamp mounting -2 - at inner tail lamp and screw on nut -3 - loosely. . Attach inner tail lamp -4 - at body cut-out and make sure grip tabs - arrows - of clamp mounting rest against body ...

2002 Audi A4 Quattro - When the car is in park the car begins to idle up and down. It also down shifts abruptly from 50 mph or above when the gas is let up. Also my check engine is on, which I took it

attach the last end to a point farthest from the Battery.  Remember to have your Stick-shift in Neutral, brake on to avoid rolling.  Turn on the Ignition key to RUN and then jump the Relay.&

...Attach the airflow distribution cable (cable 1) to the airflow distribution knob's upper control lever.   This cable can be identified as follows: Operates the footwell/defroster air ...

covers. If you see chalky corrosion on the terminals, remove it with a wire brush terminal cleaner. Clamp the red positive (+) cable onto the disabled vehicle's red positive (+) battery terminal. Next