Questions & Answers for: Singer x clamp

Question about 6038 Mechanical Sewing Machine

1 Answer

Singer 6038 needle clamp i have Singer 6038 which used only wery few times, but my needle clamp is broken... where i can get new clamp? can i instole it by myself? thanks You can order parts through ...

Ad

...too often, and I am replacing needles 3 to 6 at a time. Help and Thanks it sounds like the needle clamp screw is not tight enough or is stripped out some needle clamp screws have a **** where you ...

Ad

Question about 3116 Simple

1 Answer

how do I change needle on the needle bar, there is a needle clamp screw, undo the the needle clamp screw & take out the needle, & place the new needle in correctly, if the eye of the needle ...

How do I remove the needle clamp from the needle bar on a Singer Futura Quartet sewing machine? I had to pull the last needle out with a pliers because it was stuck and I ended up wiggling it and pull

Question about 3116 Simple

1 Answer

...thread breaksneedle may be in backwardsRaise the needle bar to the highest point then loosen the clamp screw to remove the old needle, place the new needle in the clamp with the flat side to the ...

...my sewing machine and tried to replace it, but the needle is stuck in the machine even though the clamp is all the way out. I tried pulling the needle with pliers but it won't move. Singer ...

the needle clamp is stuck unable to unscrew to change the needle how do I unscrew the needle clamp in order to change the needle it is stuck and will not turn I am therefor unable to remove the needle

after replacing the needle in my singer 8280, the needle clamp is not holding the needle tight, the needle falls down even after tighening it..how do i make the needle get fixed? when i removed the ...

Featherweight 11 117 needle clamp. Is there a wee block that goes with clamp and shaft to hold needle in. Recent answer from repair shop says it's needed. I think he is wrong. Don't know if this will ...

... 086046 but can not seem to figure it out That is because the thread guide is underneath the needle clamp, and BOTH must be removed and replaced together as a unit. In addition, the wire is held by a ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Singer Sewing Machine Experts

Cindy Wells

Level 3 Expert

6688 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Singer Sewing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...