Questions & Answers for: LG WM circuit board

Question about WM1814CW Front Load Washer

3 Answers

...circuit board. This caused a intermittent "Open" circuit indication to the computer which causes it to stop spinning and indicate "LE" on the display. I had to remove the pink connector from my ...

Ad

Question about WM-3677HW Front Load Washer / Dryer

1 Answer

...circuit board. Without a better electrical diagram, I'm kind of at a loss from there. Is there something simple, like a fuse, that could cause this problem. I hope it isn't a dead circuit board. Any ...

Ad

Question about WM-1832C Front Load Washer

3 Answers

...circuit board had worn out. They cost about 30 pence on eBay and are very easy to remove and re-solder onto the circuit board as there are only 2 pins. This saved a huge amount of money for a new ...

Question about WM-12230FB Front Load Washer

1 Answer

...have any idea what i could do to fix it, if you dont i will chuck it out and get a new one. thankyou very much if you can help me. the circuit board is shorting out need to replace the circuit ...

Question about WM-2277HW Front Load Washer

2 Answers

...circuit board.I'm assuming it is a main panel circuit or the circuit/panel board in front. What would I need to test to see if the main panel/circuit board is faulty? I had assumed that the front ...

Question about WM2277H Front Load Washer

1 Answer

purchase the PCP Assembly display. Furthermore, they say it's an easy fix and to install ..any suggestions for a quick fix? probably the main circuit board is failing. the display board is probably ok

circuit board and the fuse on the back block only has power going thru it when i hold it down The unit may not be getting the required water pressure. Check that the water valves are fully opened then

Question about WM2455 Front Load Washer

2 Answers

...circuit board had worn out. They cost about 30 pence on eBay and are very easy to remove and re-solder onto the circuit board as there are only 2 pins. Saved a huge amount of money for a new control ...

Question about WM-2277HW Front Load Washer

1 Answer

...circuit board, for these funtion to work. The circuit board came today and the harness conectors are different, not only are they different but con1 and con 2 have one less wire these functions were ...

Question about WM-2277HW Front Load Washer

1 Answer

...to the panel board and it can due to failure of the board, failure of the surge filter or the power circuit. check the panel and if there is short within the board then the panel must be ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...