Questions & Answers for: chrysler sebring 2004 oil pressure

2004 sebring How do I reset the oil sensor If you are talking about the change oil message on your cluster. You need to press step until oil change mileage appears on screen and then just press reset.

...Chrysler Sebring Oil pressure light The oil pressure light on my 2002 Chrysler Sebring stays on. Just had an oil change recently. No sign of any leaks and oil level is good. What could this be. Could ...

...chrysler sebring V6 I need to locate the oil sending (sensor) unit on 2004 chrysler sebring V6 Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. ...

...chrysler sebring idle speed is too slow. HOw 2004 chrysler sebring idle speed is too slow. HOw can I speed up the idle speed? why do you want your rpms higher while idling? you don't want them high ...

...is the oil sending unit on a 2004 v6 sebring The oil pressure sensor is located on the back of the engine, behind a heat shield. you will need to be able to work from under the vehicle to access

Chrysler Sebring, the timing belt broke, had it replaced, when i got the car back th oil light was on and would go off for a few seconds then come back on, and now it stays on all the time. The oil is

temp gauge on dash shows low yet scan tool shows about 180 as does temp gun in 2004 sebring with 2.4 liter vin x i would start with replacing the temperature sencer

...Chrysler Sebring My oil pressure light will come on after the car has warmed up but only when the rpm is less than 1000, when it isidle, or sitting still. Sometimes it just flickers but sometimes it ...

Labor time to change the thermostat housing & oil pressure sending unit on a 2004 Chrysler Sebring. 1.2 for housing and 0.8 for pressure sender-cheers denny

...2004 chryler sebring lxi 2.7 engine need to clean or change oil pressure sensor switch first off if the oil warning light is on, u need to check the oil pressure with a gauge with the engine at ...