Questions & Answers for: chrysler car reads done odometer

...chrysler town & country speedometer stuck The needed is on wrong side of the rest bar. The tach and other gages working fine. What is mostly likley problem? sit in the drivers seat close the door. ...

...car should lose energy.. leave it 30 min. or first u can try to turn on and off ignition key 3 times fast.. when i do that on my 300m on board says something "done" sory for bad english i hope i ...

...car key to the "accessory position" -- i.e., not started, but with the accessories on. Power on the diagnostic tool. Plug the attached pin connector into the Chrysler diagnostic socket located just ...

...displays on the odometer. If all is well, (or deemed well by the computer) you'll receive a message of 'done' instead of a PXXX (xxx=numbers) Code. If you relay the code to me, I can help you

...car is an '05, you will need your codes read either at the dealership, or (less expensive alternative), a national parts chain such as "Advance or Auto Zone", for FREE! They will do this service in ...

...done a full service tuneup and can't get the light off. The chances are that you will not be able to turn the lamp off without using a scanner. The scanner needs to be able to read and communicate ...

...reads nobus5. The radio and A/C work fine. Is this a fuse problem? if so where?? It sounds like one of the communication paths between the ECU and various sensors is open. It could be caused by an ...

...car continued to drive and luckily I was a street from home so I rushed to my drive pulled in and parked it and turned it off. I waited a minute and turned it it to see if it would turn over,which it ...

...car loans through our bank no ... Exterior Mirror,Power Door Locks,PowerWindows,Rear Brake Type: ... Minivan all wheel drive setups and performance - Allpar www.allpar.com/eek/awd.html Description of ...

...Chrysler pt cruiser turbo 2 weeks ago my engine light came on my car i went to auto zone for a diagnostic they gave me code P0303 cylinder 3 misfire detected so i was told to change the spark plugs ...