Questions & Answers for: Coleman checking the diode in a gh7155xhs

powermate pm0545212.02 wont generate would like to know how to test the field exciter coil on the generator.brushes are good, the capacitor test at 125 uf rating on the cap says 130 is this ok? The ...

Same Problem, diodes fell out of bridge rectifier assembly 4 of the diodes fell out of the bridge rectifier assembly board (0063525) when the solder melted on the board. Had been running the generator

i have a 3500 watt vantage that does not seem to produce enough power to run a heating blanket-the manual doesn't tell me if i need to raise the running speed in order to raise the power. Speed, ...

I have a old Coleman powermate Model PC 54 5000 I have no AC Power. I have checked the rotor and stator for continuity in the windings, no problem. I have tried exciting the brushes, got a spark, but ...

no output from coleman 5000W generator 10HP Check that engine speed is where it needs to be (does it sound like it is turning too slow or too fast?). Pull the end cover off alternator, you should be ...

I need a wiring diagram for coleman pm04350001 generator. the 220 recept. is not working and am trying to troubleshoot. High no-load voltage Capacitor with high capacity Check and replace.Low no-load ...

model pm0525312.18 serial 914080230 engine runs good but the voltage drops of from about 125volts to 90 volts when you put on about 1500 watts. does this model have a voltage regulator? what is a ...

how do you check diodes? You check the diodes with a quality Ohm meter, you should have zero ohms in one direction, reverse the test leads on the diode and you should have a high resistance, it may be

how do i test a diode You will need a multimeter. Set the meter to either the OHMS or continuity function. You need to read the diode twice, putting a probe on each side of the diode. If the diode is ...

No power from coleman powermate model # pm0435001generator. Have 41 volts at idle at brushes checkpoint. Do not know if cricut board is good, or problem on AC generator side. Any help out there? Try ...