...check timing, engine runs well, timing mark on harmonic balancer not visible, turned distributor all the way to get mark in view, extrapolated to approx 14'BTDC, checked service manual, shut down, ...
i have to reset my computer on my 98 corvette every time i start it Check that your vehicle battery is in good health and fully charged. Also check battery connections are clean and secure, as well as
check your timing as previously suggested. Place your number one cylinder in TDC by aligning the mark in the pulley with the mark in the block. Check your (distributor) rotor position and make sure is
...instrument panel or panel lights. I'm not sure.. But if you have to just take one out at a time and check it for a melted or seperated wire or burnt mark. Replace it with the same amp fuse. If you go ...
dash lights go out then come on from time to time. you have a loose connector to the dash coloum haveit checked out
check is valve timing. first locate the number 1 spark plug wire terminal on the distributor, mark its position on the base of the distributor or the intake manifold, remove the cap and turn the crank
Question about 1994 Corvette
when putting back the distributor on a1994 corvette do i need to set the timming anytime you remove a distributor on any car its wise to re check timing so yes re time it
battery light appears from time to time Try checking the connections at the alternator and grounds. Seems to be a connection problem. Is your alternator putting out at lease 13 to 14 volts
...changed I would go back to basics and checking ignition timing. Check advance in the distributor is working as the removed unit probably had an inbuilt circuit that altered the timing to suit the ...
...... Quits NO restart this time. At very cheap rates you can go for manuals from this store. Just check Chevrolet ...
Usually answered in minutes!
178 Questions
181 Questions
156 Questions
142 Questions
137 Questions