...Check ignition coil, igniter and distributor wiring connections. If connections are secure, proceed to step 4. Check spark plug wiring resistance values. Refer to Spark Plug Wire Resistance Test for ...
...ignition coil is usually 2 bolts holding it on place . Check with the manufacture what is the resistence (ohm) you should have on the coil and if you have the correct resistence readjust the ignition ...
...check wiring to ignition coil A if it was good, substitute coil A and B then look to the recorded DTC again . if changed to P0352 then it's faulty coil A if not it's ECM ignition coil "a" circuit ...
Check Engine Light On - No spark Possible Causes: - Open or short in the ignition coil circuit - Ignition coil circuit shorted to ground - Ignition coil connector - Damaged ignition coil - Damaged PCM
...ignition coil. To check the coil's secondary circuit, perform the following: Make sure that the ignition switch is turned OFF . Remove the coil wire from the center terminal of the coil. Using an ...
...check ignition fuse to coil and check see if power getting to coil if yes ignition coil or ignition module faulty.if no power getting to coil and ignition module more likely you have blowed ignition ...
...check ignition coil see if its getting battery power check black and pink ignition wire going to ignition coil.if you not getting power check the 20AMP ignition fuse.if power going to ignition ...
...the coils ? Does it have a ignition control module ? Automotive Engine Ignition Coil Testing Repair How to test an ignition coil and ignition module with test light Check the Main Relay and the
...Check the ignition coil primary coil resistance by connecting an ohmmeter between the positive (Black wire) and negative (Green wire) terminals on the coil. The resistance should be 0.4 to 0.6 ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions