Questions & Answers for: check height sensor

...height when all doors are closed or the vehicle speed exceeds 16 km/h (10 mph). Air Suspension Switch The air suspension switch supplies power to the air suspension control module. Without the air ...

Ad

Question about 2000 Expedition

2 Answers

...height sensor senses distance between frame and suspension .it will admit air to shock by controling the air compressor.check the air shock on driver side.BESURE TO TURN OFF ELECTRICAL POWER TO AIR ...

Ad

Check the height sensor. Also check to make sure that the part where the height sensor is isn't rusted away. Question: Does the compressor run continuously? (If all else fails, install a manual switch

run for about 10-20 seconds then turn off. If it won't turn off check for air leaks. But if it works normally, check the power+ground connections and the actuator at the height sensor. Hope this helps

Question about 2000 LeSabre

1 Answer

...Check the vehicle height sensor located at the rear trailing axle. It looks like a rod with 2 ball studs on both ends, this vehicle has air ride suspension, an air compressor operates as soon as the ...

...my 2003 epedition how can i check the rear height sensor to if it is working properly on my 2003expedition Check the height at the back bumper, Load the back down with Wt. Then check the height

...height sensor cause the "check ride Would a faulty height sensor cause the "check ride control" light to appear and the air pump not to work? 2001 Lincoln Continential. Hi Joseph, I believe ...

...D. 3. The ground is pin A, Black wire. 4. Ground the White wire at the height sensor, check that the vent solenoid in the ELC compressor clicks and vents the air from the system. Author: Bill ...

...Check the vehicle D-height . Refer to Trim Height Specifications and Trim Height Inspection . Are the measurements within the specified values? YES - Go to Step 6 NO - Go to Step 7 6 Perform the air ...

...on within 7 seconds after the table drive motor turns on. point to check- Paper table drive motor Paper height sensor or table lower limit sensor. Mechanical interference with the paper table ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...