Questions & Answers for: how to check ground problem


...check a ground all you do is hook gator clip to power then touch test light end to ground on radio end light comes on got a good ground (make sure not to touch any other sterio wires just the ground ...


...ground for check engine light from computer no ground to mass air flow we have replaced the brain,distrib,coil,ignitor,all relays no bad or blown fuses I am recieving signal from distribtor but no ...


Question about EA3422 Car Audio Amplifier

1 Answer

...ground. check the remote wire same way as about if you get 12 to 14.4 volt it works if not could be blown from radio or bad ground checking the ground put the black meter lead on ground wire and the ...

...check for good power and ground at the pump? The dark green with white strip is your B+ wire you should have close to battery voltage there and the black wire is ground. Its best to use the ground at ...

check pcm? which pcm pin is injector ground? where is ground located? Ground points are in different locations throughout wiring harness. If you had any work done to engine it is very possible to have

...check the ground on a heater blower motor checked motor,fuses,relays,resistor, all check good To check the Ground with a test light, attach the Ground clamp to 12 volts + and touch the tip to ANY ...

ground and check all fuses. The test light need to light bright on both terminal of the fuse. If all fuses are good .go on the tell light remove the bulbs check for power in ground. To check power and

...ground. also check for body ground as most computerized vehicles complete the circuits by grounding them. no ground or poor ground will cause the symptoms. could be as simple as cleaning battery ...

...for the particular system. The headlights and horn share the same ground. Check all ground connections under hood if fuses are known to be good. Check battery ground as well as engine to body

...check the ground circuit which can be done with a test light, just instead of grounding test light as usual use the grounding clip on a positive wire and touch tip of test light to ground, light on ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts


Level 3 Expert

85239 Answers

The Knight
The Knight

Level 3 Expert

76407 Answers

Brad Brown

Level 3 Expert

18402 Answers

Are you a Car Audio & Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides