...have replaced PCM and ingnition coil. We get a misfire code when check engine light comes on. Have also changed the fuel filter check the crank shaft position sensor. Let me know ...
...eclipse, i did that because pepboys said that would fix the problem but after i did so the car started all right but the same problem rear its head. The car will start and run properly for a few ...
check 4: If the injector harness and individual part checked good but the injector drive time is out of specification, the following troubles are suspected. (1) Poor combustion in the cylinder (faulty
...eclipse on the interstate and all of the sudden it shut off, i could not crank it right up i had to wait about 10 to 15 seconds before i was able to turn it back on, then it shut off again this ...
...Eclipse Turbo. Engine turns over but whill not start. Was told it might be the Crank shaft sensor. Is there a way for me to diagnose myself? Where is it located and can I replace Myself? Hello. One ...
...eclipse,check your sensors.As in the crank sensor. I know on the 2.4 (spyders,galants) they are located behind the lower timing cover.I believe the 420a has it on the side on the valve cover.If that ...
...eclipse in my 1995 rs and now i have no spark it will turn over but i have no spark wat should i check. have you check the crank shaft position senor found on the back side of the block towards the ...
...eclipse (also a 420A) and we have no spark. We started by checking the cam sensor and it is working properly it is upside down from the 95 but the ASD relay is operating so I assume it is intalled ...
Question about 1996 Eclipse
...crank ant press on the gas to keep it running. I was downshifting to 2nd gear one morning and Check engine and battery light was on for a couple of days. In the morning I would have to re-crank and ...
Question about 1996 Eclipse
...Eclipse is fine, I am getting no spark to the plugs. I have checked all of the ground wires for tightness and the are good. The resistance on the sensors is good. AES can rebuild the ECM if it is bad ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions