Questions & Answers for: Toshiba chassis jumper

...Chassis will have to be pulled,convergence IC's replaced w/top quality parts to prevent recall.Some excellant soldering will be needed for prevent maintenance,for instance,the steel jumper wires ...

...chassis--replace both convergence IC's for reliability. 2)Never manually move yoke rings unless yoke and/or CRT are replaced. 3)Solder any/all bad connects,esp.jumper wire connectors supplying B+ to ...

...How do I access inside of the TV body to find STK392-110? Thanks. Look for largest heatsinks on chassis.Easiest and best procedure is to pull the chassis,replace IC's,solder any /all bad ...

...chassis--check all fuses,esp, F850 & F851.They protect the B+ supplied to convergence circuit.They are found in the power supply,on edge of the main board.On the signal board,locate the large IC's ...

...1) Pull chassis 2) Check micro fuses F850,851 etc. 3)Replace STK392-110 IC's 4) Solder jumper wires 008,010,017,048,600 5) Reassemble,Test

...chassis and locate F850, F851 soldered-in fuses...check with meter..if open,replace with proper value micro fuse(s) and solder jumper wires 008,010,017, 048,600 located on signal board.Replace ...

...chassis. Toshiba recommends pulling the hard drive in and out several times to clean up the male/female contact points. Toshiba also said that if this doesn't work to contact one of their service ...

damaged hard drive when i connect my hard drive and try to open it from my computer it doesn't appear ,, how can i fix that ?? are you sure you set your Hdrive with correct jumper setting? check for ...