Questions & Answers for: chassis jumper

Ad

Question about P5LD2-VM Motherboard

1 Answer

jumper set for chassis intruced function is broken. so how can I deactivate to jump over this section while booting ? cheers Lutz Do you mean the pins for the chassis intrusion on the board are broken

Ad

Question about P5KPL-AM SE Motherboard

2 Answers

...chassis intrusion, the motherboard has dropped a jumper. The location is by the last PCI slot between the CD audio connector and the USB bus plug. (it is right next to the CLRTC jumpers) Good luck ...

Ad

...steps hope it will help you. Unplug the computer Take the MOBO battery out Remove the chassis jumper Wait a few minutes Replace the chassis jumper Replace the MOBO battery Plug the computer ...

Question about P5GC-MX/1333 - Motherboard - micro ATX - i945GC - LGA775 Socket - UDMA100, Serial ATA-300 - Eth...

1 Answer

...jumper the chassis intrusion header on the motherboard with a striaght jumper(like you'd find on a hard drive), or, easier, somewhere in the bios setup you can set Chassis Intrusion detection or ...

Question about P5GC-MX/1333 - Motherboard - micro ATX - i945GC - LGA775 Socket - UDMA100, Serial ATA-300 - Eth...

1 Answer

...jumper loose in chassis. Where does it go? If your computer is working without the jumper, take a piece of masking-tape, and tape the jumper somewhere on the inside of the computer-case, just in case ...

Question about P5KPL-AM SE Motherboard

1 Answer

...By default, on the motherboard the pin labeled chassis "signal" and "ground" are shorted with a jumper cap. You need to remove the jumper caps if you intend to use the chassis intrusion hope this ...

Question about NRL-LS Motherboard

1 Answer

...chassis opnened are tempered before please check the system" .this is information when the system is opened anly saw the bios mode.Please help me??????????? The NRL_LS has a connector for a ...

Question about P5LD2 Deluxe Motherboard

1 Answer

chassis intruder jumper" is. Then move the plastic jumper from pins 1 and 2 (left) to 2 and 3 (right). Keep them there for 10 seconds, then move the plastic piece back to pins 1 and 2. This should fix

Question about P5VD2-VM SE - Motherboard - micro ATX - P4M890 - LGA775 Socket - UDMA133, Serial ATA-300 ...

2 Answers

...jumper. At 1-35 you will see the chassis intrussion detection section. Make sure there is a metal cap covering the left 2 pins, or you will get this message all the time. Let me know if this helped, ...

Question about P4P800-VM MB, 865G/ 800FSB/ SATA/ VGA/ AUdio/ LAN/ MATX (GXMBP4P800VM) Motherboard

1 Answer

...jumper on the chassis signal is in default position... Don't know what to do... You may want to check to have good closed the chassis of the computer. Some of the pcs have intrusion system ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Computers & Internet Experts

Ekse

Level 3 Expert

13434 Answers

Marvin
Marvin

Level 3 Expert

85222 Answers

Brad Brown

Level 3 Expert

18139 Answers

Are you a Computers & Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...