Questions & Answers for: changing tires

...changing the tires, I was getting vibrations on the steering when I drive above 65MPH. Hence I took the car to the tire shop. They changed all the 4 tires again suspecting some thing wrong with the ...

...tires for winter then 75 is the best number for that. The tire is thin and cuts through snow to make contact with the road. Changing the last number 15 requires you to change the rims. That number is ...

...tires if changing front, or chuck front-tires if changing back-tires. Jack up the car enough to raise the concerned tire off the ground. Remove nuts, and pull out the tire. Put in spare tire. Hand ...

how to change the flat tire? Can not remove tire off the rim. How i get the nuts off? You're not supposed to remove the tire from the rim like with the bicycle. You take the tire nut wrench, jack and ...

...sensor that id's each tires pressure. After rotating or changing tire it must be reset to "see" pressure of each tire. Your user manual should have the proceedure. Each manufacturer is

...tires it goes 80 Most likely a diameter change. Changing tire diameters is like changing gears. I used to road race shifter karts and this was a tuning aid that was often over looked by most. Tire ...

when a tire change is done is there a reason the low air warning light goes on? ok first question did you put the exact same tire size that was on the car factory. If you change the tire size then the

tire size my tire size is 185/65 R 14. can I changed or put tire 195/60 R 15? Yes as long as u change the rims also not just the tires these numbers 195/60/15 195 is tire width 60 is tire height and ...

How do i change back tire are you sure this is correct category, if not please add more detail and repost in the correct catrgory Cindy Look in your manual or watch the attached videos, just click on ...

2007 Buell Firebolt XB9R. How do I change the back tire on a fuel 9 rFirebolt 2007. Question edited for a lot more clarity. It amuses me that posters throw a jumble of words at the page, don't read ...