Questions & Answers for: changing brake pedal switch

...brake pedal and is easy to change and relatively inexpensive. Let me know if you have any more questions. Thanks for rating my response and for using FixYa! have you tested the brake light switch? it ...

Ad

Question about 2002 X-Type

3 Answers

...sure the plunger goes in when the brake pedal goes back to normal position.if the lights stay on when the plunger is pushed in the switch is faulty and needs changing, quite common. hope this ...

Ad

...brake pedal and you will see your brake switch up along your brake pedal arm. It will either be between the brake arm and the firewall so when you brake it pushes the switch in. Or it will be between ...

Question about 2000 Windstar

1 Answer

lights There is a switch under the brake pedal ,probably this has gone ,you must change it,when you press the brake pedal,the pedal hits the switch then it lights the brake bulb ,check for this switch

brake pedal several times to get the lights to turnoff. Now that doesn't work. There is a brake pedal switch located above the brake pedal under the dash that is a plunger type switch. Your plunger is

...button depress. The test light should light or not light changing as you press and release the pedal. Another way to do this is to change the brake pedal switch and see if it works. I hope this

...brake pedal to look for?? there is a switch above the brake pedal that turns the brake lights on when u depress the pedal, use a volt meter set to DC volts and check for voltage to the switch and out ...

Question about 2002 A4

1 Answer

brake pedal down a few inches, then pull the switch plunger rod out of the switch toward the brake pedal arm, as far as you can without using excessive force. Next, return the brake pedal to the pedal

...brake pedal mounts to the pedal assembly there is an electric switch on the brake pedal arm that has a tang that is pushed in when you apply the brake. Replace said switch. If this is confusing watch ...

Brake Pedal Position Switch Test 1.) Disconnect the 4P connector from the switch (A). 2.) Remove the brake pedal position switch. 3.) Check for continuity between the terminals according to the table,

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...