Question about Centennial 3.2 cu. ft. SuperSize Plus Top Load Washer
while it is still filling, water fills while on the spin cycle, etc. Any help? Replace the "water inlet valve" on your machine. If you could post your model number I can point you to the part you need
Question about Centennial 3.2 cu. ft. SuperSize Plus Top Load Washer
water inlet valve is burnt out 4 there is no power signal getting to the water inlet valve try putting the cold water hose onto the hot water inlet switch the washer to hot wash see if the water comes
Question about Centennial 3.2 cu. ft. SuperSize Plus Top Load Washer
into washer water will not enter the tub. Replaced water inlet valve. Checked inlet voltage 120v. No outlet voltage at water inlet valve. Not open presenting of water. The filter of water was littered
Question about Centennial 3.2 cu. ft. SuperSize Plus Top Load Washer
...up to the Washer Water Inlet Control Valves. Shut the water off at the Main water valves in the wall. Disconnect the hoses from the Washer and check the filters inside the Water Inlet Control
Question about Centennial 3.2 cu. ft. SuperSize Plus Top Load Washer
...water inlet valve?? Hi, If your washing machine will not fill, only hot or cold will fill or is slow tofill then read these tips. I have covered many of the things that can happen inthese tips... ...
Question about Centennial 3.2 cu. ft. SuperSize Plus Top Load Washer
Maytag Centennial Washer model MVWC6ESWW1: Hot water wash not working anymore The water inlet valve has a stuck solenoid and it will need to be replaced. Here is the part to order.
Question about Centennial 3.2 cu. ft. SuperSize Plus Top Load Washer
inlet of the water line. Once the water comes into the system the WATER LEVEL SENSOR - normally a pressure switch- must activate at the preset/chosen level to give the signal to the program controller
...will not fill Please check the INLET to the hot water line. It could be clogged. of so remove and flush or replace valve, if there is no supply to the valve it can be related to the control
...inlet water solenoid valve , remove blue hose and check you have water to machine if ok check you have power to valve if you have power and water and still no water going into machine then its your ...
Question about Centennial Top Load Washer
...water inlet valve how ever the problem is still there. I did reverse the hot & cold hoses..............it did the same thing with the cold water Hi Daniel. I've heard of this problem before. In that ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions