Questions & Answers for: Toyota how to change a tap washer

...and should help clean out any blockages. Sounds like low engine oil level CHECK RIGHT NOW, change oil and filter immediately Engines under strain, (Like pulling trailers) will use oil where ...

...tap water in the washer fluid reservoir, it may be clogged up. Use only washer fluid because the nozzle have very small opening, almost like hair thin so they can be clogged up by tap waters calcium ...

still same problem. Tap on the mass air flow,and see if it changes idle,if it does,it is the problem,If the throttle position has to be tapped on,then it could be defective,change it out for a new one

of the engine, though continue to do its job. An oil change with an additive included may help in quitening things down. A bottom end tap/rattle (or 'knock') - the sooner that is sorted out the better

...washer Remove the mounting nuts and washers. Next, remove the outside mounting nuts and washers Using a brass bar and hammer, tap on the bolt ends, then remove the cone washers. Using a brass bar and ...

...change the bearing but i can't take the wheel locks off or hub IF EQUIPPED WITH FREE WHEELING HUB. SET THE CONTROL HANDLE TO FREE.REMOVE THE COVER BOLTS AND PULL OFF THE COVER.REMOVE THE CENTER BOLT ...

...change the rear brake shoes on a 95 toyota granvia , is the hub nut left hand or right hand thread as it wont budge, thanx. That nut is a locking nut and requires you to remove a locking washer from ...

missing bolt from alternator missing bolt from under the alternator Any bolt from a hardware store will do, but if you can, get the largest one that will fit the hole, and try to get a metric, not an ...

engine is making tapping noise at rear lower end changed oil and added to too much oil and tried to start it up then fixed oil problem now the engine makes tapping noise when engine gets warmed up ...

How do u check if a mass air flow sensor is not working on 95 Toyota 4runner One way is to disconnect it and see if the problem gets worse, or try tapping it lightly while the motor is running. If it ...