Questions & Answers for: Estate how to change a tap washer

...Washer How do I change a drain pump? Here ya go. I hope this information helps you. Read the instructions thoroughly BEFORE attempting. This is a simple repair that can be accomplished easily if you ...

...tap the center portion of the coupling until the opening of the coupling is flush with the shaft. DO NOT hit the prongs or they will break. Do the same for the Drive Motor. Make sure you place the ...

Taps that connect to washer water hoses are leaking Copper taps that lead to the washing machine water hoses (both hot and cold) are dripping from the spout even with the value closed. How do I fix ...

how do I lift the top off the automatic top load washer to replace the little side switch on the right side of the machine were the top sets down in to? Good day, You have to remove the front of the ...

Water drips inside tub when washer is not in use. Can't tell exactly where it's coming from or how to get inside the back. Water valve needs replacing. Determine which one by turning off either hot or

...get to the water valve so you can replace it you must flip up the controls: This video shows how to change the motor on one of these washers. Not all are the same but the controls all flip up: I have ...

Washer stopped working mid cycle. Filled up with water still. The washer will not make a noise. Completely dead. Hello, Welcome to FixYa. The scenario you describe is usually associated with a faulty ...

...tap completely to get hot washer for wash cycle. Then turn cold tap back on for rinse cycle. One simple thing to try is to clean them screens on the water valve. Remove the hoses and get the screens ...

...washer is not working when I put it on heavy wash cycle I might put it on the casual wash cycle. If you change the wash cycle and it goes through the complete cycle it is probably the timer which is ...

...Washer fills with water and then that's it won't do nothing else. I can turn the timer to any position still nothing. It does not have a lid switch it has been removed and the wires tied together . ...