...reception to cable. i have a one for all remote, and after selecting menu i cant scroll down to the air/cable selection to effect a change you will need to use your factory remote to do this
...air setting to cable setting I am not able to switch from air setting to cable setting on tv with cable universal remote. The cable universal remote has been programmed to turn off/on tv and volume, ...
Question about LC-42D43U 42 in. LCD HDTV
Sharp Electronics Corporation. The display will populate on screen any time there is a change to the incoming signal (mono to stereo audio, weak/fluctuating signal strength). Unfortunately there is no
...change from air to cable. I have both the manuel and remote. Once you navigate to the Air/cable setting in the menu (menu - Set up - CH setting) press the Vol + button to access. make selection once ...
...Sharp LC46sb54u does not let you program digital channels from the antenna. The option is deleted on the setup menu. How do you get the digital option back? The manual says once you program channels ...
...Sharp? You may have to change / adjust the settings on your tv to use cable vs over the air antenna. When power was lost, this setting may have defaulted back to factory (Air / Antenna). If the cable ...
Question about 13VT-R100 13 in. TV/VCR Combo
change it from cable to air. Can someone help? For sharp TV-VCR Combo with universal remore control, 1/ Start by pressing SET & TV at the same time, the LED goes solid RED 2/ Press 009 or whatever
Question about Aquos LC-46D62U 46 in. LCD HDTV
...sharp tv wont change channels not even on tv buttons I am going to assume you have auto-programmed the TV. If you haven't, do so and let it finish. Make sure you are in the right mode, e.g. Antenna ...
Question about Aquos LC-46D62U 46 in. LCD HDTV
...sharp aquos. Have to change cable settings on ezsetup to get it back. Here a click and tv switches to air instead of cable. Try a hard reset and see if that helps, if it doesn't you may need a new ...
Question about Aquos LC-46D62U 46 in. LCD HDTV
Model GB004WJSA 60 INCH TV. How can I change from cable to antenna? go into set up and change from cable to tv air then channel search make sure to have a antenna connected to the coax connector
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions