Question about Pebble 3 ID Card Printer Package (P/N MIDS-E-SC)
...change the ribbon type at the printer properties? You must choose the black ribbon or monochrome in old drivers. Check for ribbon type in properties. Open Dialog with printer and check ribbon type ...
...change of the Ribbon? Thanks for the answer. imel... Just check for the ribbon type setting in driver . It may be required to be corrected . Also try downloading new firmware from Evolis site for ...
I changed the ribbon to the monochrome R3012, but the printer has the NO RIBBON light on and it won't recognize it. I set the printing references to that ribbon style, the ribbon is not torn, I have ...
Question about Pebble 3 ID Card Printer Package (P/N MIDS-E-SC)
...ribbon quality or change the ribbons which are not in good condition. Re prepare those ribbons in cartridge and then install the cartridge properly. Check the printer settings also and reboot it. Try ...
Evolis pebble 4 shows the end of ribbon light... ...when black ribbon installed and I have changed the ribbon type in printer and the ribbon is installed in the same way as the colour ribbon that does
Question about Pebble 3 ID Card Printer Package (P/N MIDS-E-SC)
...change the ink ribbon. The ribbon wheel is hard to turn. I think it is in need of a lube job. I purchased it 3 years ago second hand. never been serviced I'm sorry. Only working with genuine ...
Question about PEBBLE 4 Led Card Printer
...change to black ribbon K it prints. What is the problem. It sounds like your ribbon setting in the printer-driver is set to the R2011 (or R2211) K ribbon. It should be set to R3011 for the full-color ...
Question about Primacy ID Card Printer
I keep getting a 'NO ribbon" MESSAGE ,and i have changed the ribbon four times ,using a new ribbon each time,but the problem persists. What should i do to correct this.? Ok ,# 1 Purchase Electronic ...
Question about Primacy ID Card Printer
...change the ribbon type in the driver both Mac and Windows and directly through the com tool Pr;ko responds OK but the printer simply does not recognize the change Rr responds k. I have repeatedly ...
Question about Primacy ID Card Printer
...will flash if you have fewer than about 20-25 cards loaded. Fill the hopper and see if the behavior changes. 2. The card not printing/rejecting may be a symptom of your having the driver set for a ...
Usually answered in minutes!
29 Questions
20 Questions
12 Questions