Questions & Answers for: how do i change the number of rings Cars & Trucks

Ad

Question about 2004 Endeavor

3 Answers

...change the bulb from inside the engine compartment . raise the hood and feel for a plastic retaining ring in the back of the headlite. Loosen 1/4 turn and bulb socket and old bulb will pull out from ...

Ad

isn't difficult to remove the cover and you are likely due for a lube change anyhow. Good luck!! The only part of the number that may be the ratio is the 352 which could be 3,52:1 but don't trust that

Ad

...roller rocker cam. There is too big a difference between the two ring gear teeth numbers. You could change the starter drive pinion to suit the new ring gear though. NOT A CORRECT ANSWER. ZED ...

...change the ring and pinion gear. The side and spider gears should not have to be changed unless there is something wrong with them.Changing a rear end gear set takes a fair bit of knowledge and ...

Question about 1989 S-10 Blazer

2 Answers

ROUGH IDLE MOWER STARTED IDLEING ROUGH AFTER RECENT FILL UP. THOUGHT MIGHT BE BAD GAS. CHANGED THE GAS , PLUGS, FUEL FILTER. STILL ROUGH IDLE BUT STARTS FINE.????? You-Tube video "LMDl_dAv2zI" ...

Question about 1990 Camry

1 Answer

...number 2 plug. What is the cause of this? Either worn valve guides, valve guide oil seals on that particular cylinder, or worn piston rings. You need to perform a compression test to find out which ...

Question about 1990 Camry

1 Answer

...car now and dont no what to do, i want to get it fixed and keep it but im thinking what are the changes of having flywheel changed and it still doesnt work, the engine management light isnt on??? ...

number 1 spraying fuel once ignition is in (on) position Sounds like the relay is stuck in an open position and needs to be replaced. Likely the O ring on the top of the fuel injector that seals it to

...number of possible reasons to get smoke including: Cylinder bore scored, causing rings to not seat. Damaged rings during piston replacement Valve guides leaking Mixture wrong (is smoke blue, white or ...

...change the ring and pinion .dose the teeth of the ring and pinion reer and front should be same number of teeth NO--- Check Gear Ratio On Tag Or Tube--Front and Rear Are Not The Same. Or Count Teeth ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...