...albania , and I need where to find a fuse for fusing unit of konica bizhub c250 to reset him. if fusing unit life is over you must change it. other spearparts you can order from konicaminolta
...konica minolta c451 error c3921 not known what to do C3921: Fusing sensor wire breaks detection (Center of the heating roller)... ? At the warm-up stage, the heating roller thermistor/3 voltage does ...
konica minolta 2490mf what is 18h prblem,,,,, thanks 18H: Heating roller warm-up failure 1 Check the fusing unit for correct installation (whether it is secured in position). 2 Check the fusing unit, ...
Question about bizhub C250 All-In-One Laser Printer
...fuse. My konica minolta bizhub c252 is continuously restarting i have changed supply, supply board even relay board but restarting problem didnt solve i am so tiered plz help me to solve this
Question about bizhub C250 All-In-One Laser Printer
konica minolta bizub 164 call service c3451 tell how solve Warming-up failure1 Check the fusing unit for correct installation. 2 Check the open/close operation of the right door. 3 Check the fusing ...
Question about bizhub C250 All-In-One Laser Printer
...Konica minolta C450 showing error code C3752. How to resolve this problem Dear The temp. of fusing p. roller is abnormal high. pl. check the followings. 1-Check the Fusing Unit for correct ...
Question about bizhub C250 All-In-One Laser Printer
Konica Minolta 215 error C0F501 solution Fusing Pressure Roller warm-up failure • The voltage of the Fusing Pressure Roller Thermistor does not increase by five steps within 20 sec. after the predrive
Question about bizhub C250 All-In-One Laser Printer
...change one fuse. You need a new 50-80 ma fuse. Remove the belt from the machine, the fuse is in the left side of the belt, under the left handle. Replace it with a good same fuse. For detailed guide ...
Question about bizhub C250 All-In-One Laser Printer
...konica minolta bizhub 215. Description Warming-up failure - The thermistor/1 (TH1) detected that the temperature of the surface of the fusing roller did not reach the specified level even after the ...
Question about bizhub C250 All-In-One Laser Printer
...konica minolta bizhub 164 copier, shows on display c3451, without taking any command,pl suggest? Description Warming-up failure - The surface temperature of the fusing roller does not reach a given ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions