Questions & Answers for: change front wheel bearing 1991

...front wheel bearing on my 1991 Ford Festiva, and my mechanic told me that the races in the spindle unit that housed the bearings were worn and that I would soon have to replace the spindle or face ...

...Front wheel drive transmissions are usually check through the speedometer housing, then the fill level is checked by using the speedometer cable as a dipstick.There is a mark on the speedometer cable ...

...Hub) How do you remove and install bearings (front hub) on a 1991 Ford Festiva? these must be pressed in and out. u will need to have a machine shop remove the old bearing and install the new ...

...front wheel bearing worn out needs replacing can you provide me with manual to help me replace the front wheel bearing I do have the manual and there are several on eBay all the time for Festivas, ...

...front wheel bearings on my 93 Ford Festiva. Have not worked on this part of the car before. So before starting the job, is there anything about it that I should be especially aware of? Any surprises ...

i have a loud roaring/moaning sound comming from the right front tire/wheel on a 93 ford festiva Check the brakes, maybe the bearings in the hub, or your CV axle.

tranny fluid or front wheel bearing? Sounds like the CV joint is shot - this is a front-wheel drive car, right. The side that it jumps to has a bad CV bearing that needs to be replaced would be my bet

...front wheel bearing on a ford festiva 1998 Remove the front hub assembly complete then take it to a enginnering shop to have old one pressed out and new one pressed in ,as its extremely dangerous to ...

...wheel bearing to me. i bought a 91 festiva 3 weeks ago and ive had to replace the bearings on both sides. really be careful driving on that because it could straight up lock the wheel on you or ...

...front wheel bearing and oil seals. in the back have replace inner ball bearings but not the outside ones. Still have a noise coming from rear passenger side of car. Drove it 9 miles. But yet no heat ...