Questions & Answers for: Chevrolet Blazer how change cooler

...change heat sensor. need to know where it is located. if youre driving down the road with decent heat and all of a sudden it gets cooler, and the engine temperature remains normal, i would strongly ...

...is too much for a hose. do you think i can change the oil cooler hose by myself in my garage? thank you. Yes you should be able to change it by yourself. It is pretty simple. It will save alot of ...

when trans gets hot i have no first gear or overdive i have a 1996 blazer 4x4 4.3. when the car gets to operating tempeture i lose first gear and overdrive but it shifts great when cold You could ...

...cooler than the other but, only slightly. the heater core could be clogged. I fixed mine by removing the hoses from the connections on the firewall and back flushing using a garden hose until the ...

we have a 2002 chevy blazer, we just replaced the radiator, and leaking head gasket seals because when we try to drive the truck with our snow plow on it over heats.....we can drive it anywhere ...

...change oil not so quickly (4-6 months). Transmission Fluid gets changes every 30,000 miles on all vehicles You can by pass the radiator cooler and put a trans cooler in front of the condenser Lot of ...

...cooler lines to the radiator. I flushed the radiator, tranny fluid, gave it an oil change,changed the fuel filter (which had pressure), changed plugs, wires, cap rotor, ignition coil, S-Belt, added ...

...94 4 wheel drive 4.3 vortec oil cooler is leaking oil bad under me moter i put new seais but it is still doing it what would make it do that REPLACE IT IF THAT DOESN'T WORK CHANGE FRONT MAIN ...

...change the seal you must first remove the lines close to block and the you shoul be able to unscrew the oil cooler adapter from the block, may require an allen wrench to loosen. Then you should ...

...change.if transmission fluid was real low check for transmission fluid leaks around transmission oil pan gasket or fluid leaks around cooler lines or torque converter shaft seal. if you getting steam ...