Questions & Answers for: chainsaw shuts running awhile

Question about Polesaw Wizard

1 Answer

shuts off worked well for a while, but after using it for awhile motor will run fine until you put saw against wood, and then it shuts itself off. You can restart it, but again once you put it against

Ad

Question about 16 In 4.5 Hp Electric Chainsaw With Carrying Case MCC4516FK

3 Answers

chainsaw is an absolute nightmare. Revs uncontrollably and is the second one that I've had that did this. The first was exchanged and now, just after the warranty expired I'm stuck with this junk that

Ad

Question about Briggs Stratton Intek V - Twin Vertical Ohv Engine with Electric Start 22 Hp, 1" X 3 5/32" Shaft, ModelNo. 44K777 - 0027 - E1

1 Answer

...the fuel filter. Sawmills are dusty places and timber dust can clog-up air filters. Air filters in chainsaws are cleaned hourly for max

Question about "Chain Saw - 16" Bar, 3 Hp

3 Answers

...shuts off after a few seconds. I have a Poulan Pro 310 that started doing the same thing at the same time. I bought new spark plugs for each, as it had been a lot of running time since last ...

Question about "Chain Saw - 16" Bar, 3 Hp

1 Answer

...running awhile and shuting it off it wont start back up until it cools back down I am going to assume you are following the warm start procedure in your manual. Most start problems with 2-cycle ...

Question about "Chain Saw - 16" Bar, 3 Hp

1 Answer

14hp kohler on craftsman mower will run for awhile then runs out oh gas. I have replaced filter & fuel lines & cleaned out fuel tank. Will run for awhile until filter goes dry ..... Then ...

Question about "Chain Saw - 16" Bar, 3 Hp

1 Answer

Have the small Eager ****** model. Starts decent when engine is cold...run it for awhile and shut it off will not start until engine is cooled off. Poor quaility, or stale fuel can cause this, it is ...

Question about Pro 42CC 2 Cycle Chainsaw, 18"

1 Answer

hi 260 42cc starts good but after using for awhile and shut it off it wont start, it will fire and run a few seconds and quits, does this every time but wont start and run, if i let it sit a few hrs ...

Question about Pro 42CC 2 Cycle Chainsaw, 18"

1 Answer

no spark after using it for awhile saw starts back up but will stop again just like you shut the switch off I tried a new spark plug but didn't help coil is going bad replace it. it will run fine.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Garden Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

john h

Level 3 Expert

29494 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...