Question about M406A 399K BTU Cupro Nickel Pool or Spa Natural Gas Heater
I have a Rheem 406 pool heater. the status code in the display reads " CFH" Call for Heat. The unit is not turning on . What is CFH and how do I reset the furnace? call for heat check ignitor
Question about Rp2100 Pool & Spa Heater Lonox 407k Btu Natural Gas Polymer Header Digital Rp407aenc
When we tried to light the heater the CFH shows, then I get a SPK which stays on for aroound 1 minute, then I get a LO. The heater never lites. The CFH is a Call For Heat. The SPK tells you that it is
Question about 266K to 399K BTU Swimming Pool Natural Gas Heater ()
I have model # p-m267a-nc-c it comes on I git error cfh then after a while i git hl2 and it wont heat after that. HELP Please TKS "CFH" is Call for heat. That means your heater is trying to fire (not ...
Question about Raypak 130,000 BTU Propane Gas Pool H...
What does CFH means on my control board? "call for heat", in other words the heater realizes the water temperature is below the set-point on the heater and therefore wants to turn on and heat the ...
Burner comes on for a moment and kicks out displaying CFH on the screen. once that happens it starts over again and displays SPK on the screen and ignites all over again. It will not maintain a flame ...
Question about 266K to 399K BTU Swimming Pool Natural Gas Heater ()
what is cfh error code for inground pool heater Cfh is call for ?? heat. That is Not an error code. As stated earlier, = Call For Heat When water Temperature falls 2° lower then Set Temp, a Heat ...
What does CFH mean What does error codeCFH mean on a themes gas pool heater this is not an error code. it means a call for heat. the pool water temp is colder than your tstat set point
Question about 266K to 399K BTU Swimming Pool Natural Gas Heater ()
What should we do all that comes up on our Rheem pool heater is CFH? It has been working fine. When we turned it on this time this CFH came up. calling for heat check ignitor and gas flow
raypack pool heater trouble codes heater ignites then turns off. Code 'CFH' displayed check flame sensor if wired 120 volt see wiring on inside of panel
...each, and had 11.19 CFH. This took a size 55 numbered bit. The sideburner, or "pots and pans" cooker is 10,000 BTU, 9.325 CFH, and took a size 56 bit. There are other sites with information as
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions