Questions & Answers for: ceiling fan rattles

...fan, it is while heating. It may be the stirrer in the ceiling area. You can find helpful exploded view diagrams and order parts by entering your full model number here: http://tinyurl.com/gv383 If ...

...fan adjacent to the light bulb in the ceiling of the microwave that is making rattling noise. Since microwave is working except for the noise, is there anything that can check/clean-up to get rid of ...

...Ceiling joist in the attic. The support bar that the fan motor is screwed to is not removable. It appears to be pressed or riveted into the fan housing. Is there some trick to removing the motor from ...

ceiling fan made a few slight high-pitched ticking rattles (quiet and intermittent but annoying) when it was wired up and sitting on top of my stepladder. Then I installed it (had to cut out a 21'' by

there is an intermittent hum that occurs in my new Broan fan there is an intermittent hum that occurs when I turn my newly installed fan on. The Fan is hung level and does not seem to be rattling or ...

fan motor,open the fridge door,up near the ceiling on the right side you'll see the model number,send it to me,let me know if you found ice or frost on the back wall of the freezer or what you see and

...ceiling you'll see a tag with the model number,tell them you need a start device and they will sell you one.do you hear a clicking sound or smell anything,when my device went i could smell ...

fan. When I check for voltage with my Fluke. I have not schematic. Where's the control board and what should I check for? Hello, You should first check the start relay which is located on the side

...device or the compressor itself.open the fridge door,look up on the right hand wall up near the ceiling and you'll see the model number,call your parts store,give them the model number and ...

...ceiling,top freezer look on left side wall.if the compressor isn't running most likely you have a bad start device located on the side of compressor,pull out the fridge,unplug it,remove the back ...