Questions & Answers for: ccu repair

repair or could just be wire harness? Help "F11" is a Serial Communications error. This is usually an indication of a failed Central Control Unit (CCU). This is the main computer for the washer and is

...repair the CCU for you. Mainly for the F11 Error Code. I see on the site that they have repaired 95 of them with 100% feedback. ...

...I remove the control panel? I need to remove the control panel of my washing machine to remove the CCU to have it repaired. Can you help?   The ccu isnt behind the panel. The ccu is under the ...

...repair man say it needs ccu. How can I replace it and where can I purchase the part? Can this error code mean anything other than bad ccu? Remove the bottom front panel 2-3 screws at the very bottom. ...

...CCU. Trick to repair it include testing and eventually reheating the solder joint of the two on-board relays, cleaning connector contacts with circuit cleaner solution. This in case that the problem ...

...CCU. Trick to repair it include testing and eventually reheating the solder joint of the two on-board relays, cleaning connector contacts with circuit cleaner solution. This in case that the problem ...

...CCU board) With this repair you need to remove the circuit board from the inside, top, back of the machine. Mark all the connections before you take them out then remove the entire plastic case with ...

...repair takes less than an hour. If not, just remove the CCU case with board and take it, along with this response, to a good appliance repair shop and they should be able to help you out. Good

CCU) and the Motor Control Unit (MCU) cannot be sent correctly. repair: Check Wire Harness connectors to the MCU, the motor, and Central Control Unit (CCU)Check the Drive system for any worn or failed

...these joints are the largest ones on the board) If you're not up on your soldering techniques you can take the CCU to a good appliance repair shop and they should be able to help you out. Good