Questions & Answers for: catriver

Question about KUDS24SE Built-in Dishwasher

1 Answer

getting the door inner panel off Thank you Catriver for your quick response. I removed all the screws from the inner panel and was able to lift it off except for the vent in the upper left-hand corner


Question about 3.8 cu. ft. HE3t Front Load Washer

1 Answer

Same Problem as Carmal Message for Catriver: Can you tell me the part number for a new water inlet valve for my Kenmore HE3? Model number is 110.44832.200. Thanks, FigGirl I believe you already have ...


Question about MAH8700A Front Load Washer

3 Answers

...will not open I have the same problem as the one described below by Artweavaly. As suggested by catriver's response (second paragraph below), I went into test mode and did a self diag. After a ...

Question about 24 in. KUDS02FRSS Stainless Steel Built-in Dishwasher

2 Answers

...a self test and clear the fault. The test lasts for about 25 minutes. Let us know it this works, back. Try high temp scrub-sani-high temp-sani. If that's not it, remove the bottom ...

Question about 24 in. 16582 Built-in Dishwasher

2 Answers

flow and the top arm will not spin. Im going to try to attach a pic of the chopper assy and screen. back Thank you Catriver! You were in the zone! It's working like new! Many thanks

Question about Neptune MDE5500AY Electric Dryer

3 Answers

...remove a back panel to do so. I removed all bolts a screws but don see a way to remove the panel. Catriver was right on the mark. Took a little bit of doing but I was able to fix the problem myself ...

Question about Elite 45986 Front Load Washer

8 Answers

...the filter out. Clean out all the stuff and put it back in. See if the washer comes back to back Also, please check for any stucked clothe inside a washer'ssidfe( they are ...

Question about DPSR483EA Electric Dryer

2 Answers

...dryer (GE DPSR475EWOWW)and I removed the drum as explained in the June 23 note between poorman1 & catriver. I found the noise by spinning the fan from its motor and it was dragging against the

Question about GGQ8831L Gas Dryer

6 Answers

...good. If not, the thermal fuse may be blown or the ignitor itself and thus the reason for no heat. Catriver. i had the same problem, and found you can use 10 amp auto fuse for a temporary fix. heat ...

Question about Oasis HE 27082 Top Load Washer

1 Answer

...I don't think you need the motor cover.When you receive the parts, you can contact me at If you need any help putting them in I will be happy to assist you.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Dishwashers Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Brad Brown

Level 3 Expert

19187 Answers

john h

Level 3 Expert

29494 Answers

Are you a Dishwashers Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides