Questions & Answers for: Jaguar catalytic converter

...catalytic converter itself is no longer functioning properly. The other likely thing is the rear O2 (oxygen) sensor is no longer working properly. Other things could include exhaust leaks, damaged ...

Catalytic Converter appears to be blocked. Loss Catalytic Converter appears to be blocked. Loss of power on incline. Goes Ok on the flat. How does one remove and replace the converter replacement is ...

...catalytic converter. The #1 cylinder is located at the front spark plug on the right or the passenger side of the vehicle, so Bank-1 is on the right side of the vehicle, and the O2 sensor that ...

...catalytic converter and one next to it by or in the exhaust manifold and then one in the middle of the back catalytic converter and then again one in the back off by the exhaust manifold. I have a ...

...catalytic converter is not working well on bank one and code 430 is the same thing for bank two.There is an O2 sensor in front and behind each cat.  The computer uses the readings from the front ...

...catalytic converter efficiency below threshold. Road test the vehicle and bring it back into the shop, raise on lift while running, (don't shut it off) and use a temperature scan probe to check the ...

...catalytic converter can you remove convertors The catalytic converter, looks and if fitted to the system like a silencer box, some people have a pipe made up to replace the converter, straight swop, ...

Where are the catalytic converters located location of the 3 catalytic converters, specifically the one in front There are only two catalytic converters. They are of a high efficiency type and as such

...catalytic converter to get red hot in a 2004 Jaguar Too much fuel. Have the codes read. Could be a vacuum leak(big one). Cats are pretty much gone though. They melt. running rich and cat converter ...

...catalytic converter. can i fix it myself Possibly, if you have the correct tools and can weld. If you are capable of cutting out the bad catalytic converter and welding in a new one you can fix it ...