...to run. starts then wont rev, just stalls. re-prime and start with choke then stops. plug is ok, fresh fuel. there are two screws on the carburator one is for air other for gas .that need ...
...now wont start Try putting a little gas in the carburator and make sure the choke is on full then try starting it. You may have to try this a couple of times in order for the gas to get primed. ...
wont start unless primed then it fine you can shut it off starts right back up but it sits for more than about 4 hours you ll have to do it again what year and brand of car. if newer car check fuel ...
wont start i do prime it every third pull any ideas? Chances are your carburator has dirt in it. It doesn't take much to clog those little carbs. Empty the gas tank and clean it. Purchase a can of
...wont start changed plug still doesnt even fire Hello, Please make sure you have no leaks on the carburetor, if it has not been turned om for a long time, prime the engine for cold start. Here is how ...
wont start after warming up after driving for a while and car warms up it will not restart until the motor gets cold. Likely vapor lock if one of the Carburated units. If it is EFI, Fuel pump ...
Question about 42-Inch Steel Deck 17.5 HP Briggs & Stratton I/C Engine With 6 Speed
wont keep running I have cleaned the tank and changed the filter. cleaned the carburator with cleaner there is a solenoid on the bottom of the carb is that stuck is there power going to the solenoid a
Question about 42-Inch Steel Deck 17.5 HP Briggs & Stratton I/C Engine With 6 Speed
carburator and installed kit... still wont start good spark... primer bulb replaced,,, how does the fuel get to the clyinder after fuel bowl is positively primed threw jets if the carb was stored with
Question about 42-Inch Steel Deck 17.5 HP Briggs & Stratton I/C Engine With 6 Speed
carburator to start If the primer buld is hard to push or wont return to shape like its supposed to then there is an obstruction in the carb. If it just wont move fuel then there is a hole in the fuel
Question about 2010 250 SX
...packing. cleaned carburator. still wont fire. even triied a couple drops of feul into the cylinder head to prime it I would first check the compresion to see if you do it will need a propper
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions