Questions & Answers for: Harley Davidson XL 1200 C Sportster Custom carb install

Question about 2004 XL 1200 C Sportster Custom

1 Answer

...time keeping it running. it seems i need a fuel line to have a 90 degree bend to it to reach the carb. do you have any suggestions as to how to can fix this with my original parts? You could ...

Ad

Question about 2005 XL 1200 C Sportster Custom

2 Answers

how do i tune my mukuni carbeurator? I have a 2005 Sportster 1200c, i installed the mikuni 42mm carb which works fine at low speeds but when i reach 60mph or higher and cruise my bike chokes out. this

Ad

Question about 2006 XL 1200 C Sportster Custom

1 Answer

will not idle problem occurred suddenly installed new plugs , new air claener fresh fuel hi buddy is it carb if so on carb is a screw turn this in the idle screw below if not carb get back to me

Question about 2000 XL 1200 C Sportster Custom

1 Answer

...and exhaust gears on mark as described in manual, Test fired it and its spitting fuel out the carb and the rear cylinder is running much hotter than the front any ideas or advice is much ...

Question about 2000 XL 1200 C Sportster Custom

1 Answer

...carb for cleaning wrote down how manny turns out etc to nain jet /idle jet blur blur lost paper its an 89 sporster no stage tunningh standard settings No sweat. Screw the idle mixture screw in until ...

Question about 2003 XL 1200 C Sportster Custom

1 Answer

...carb is running lean. Now, the bikes come jetted very lean from the factory so that they meet EPA emissions standards. The way I usually fix this problem is to go up one size on the slow jet. The ...

Question about 2004 XL 1200 C Sportster Custom

1 Answer

carb by removing the needle and adding a single 3mm flat washer under the needle stop. The small flat washer is approx. 0.023" thick. The stop is the 'swelled' portion of the needle that keeps if from

Question about 2005 XL 1200 C Sportster Custom

1 Answer

...on 2005 xl 1200c. Also, same bike has 34000 miles all stock, except big ******. started acting like carb problem earlier this year. I am in NW corner of NM and ride alot in Colorado, altitude from ...

...to much about the bike history just bought it. The bike after market loud exhaust system. Possibly carb needs rejetting after aftermarket exhaust was ...

...install. That resolved the clicking sounds and the engine fired up with a rough idle. I adjusted the choke(full out) for about 2 minutes and then pushed in mid-way. I road the bike for a new minutes ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...