Question about 24a 021h700 4.5 Horsepower Chipper/Shredder/Vacuum, Push Model
...carb diaphram it is not that hard. The carb and gas tank are removable with just 2 bolts after the air-cleaner is removed. One bolt with spacer is near the gas filler opening and takes a 1/2 inch ...
Question about 24a 021h700 4.5 Horsepower Chipper/Shredder/Vacuum, Push Model
...carb, this diaphram shoud be flat show no signs of blistering or cracks, under this diaphram is the main inlet screen, this should be clean, any doubt and it should be replaced, the metering diaphram ...
Question about 24a 021h700 4.5 Horsepower Chipper/Shredder/Vacuum, Push Model
...diaphram in carb could be suspect. is this common? what else should i look for? Start with the easy things first, pull the fuel hose from the tank and replace the filter on the end, check the fuel ...
Question about 24a 021h700 4.5 Horsepower Chipper/Shredder/Vacuum, Push Model
...carb body followed by the diaphram, followed by the cover and securing screws, the metering lever should be set level with either the sides of the carb body or the base of the carb body dependent on ...
Question about 24a 021h700 4.5 Horsepower Chipper/Shredder/Vacuum, Push Model
...carb diaphram & gasket correctly ,now it wont even start,there is a good spark but the plug is dry when removed indicating fuel shortage,springs & linkages ok would appreciate some ideas ...
Question about 24a 021h700 4.5 Horsepower Chipper/Shredder/Vacuum, Push Model
diaphram goes against the carb body followed by the gasket and the cover, this is because there will be two small flaps on the diaphram that act as non return valves, so must be against the carb body,
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...diaphram carb, this is for two reason, the fuel is below the carb so there is no gravity feed for the fuel, and the machine is used in many different positions which would make a standard carb flood, ...
...diaphram in the side of the carb. Look for a plate approx 1"x1.5" with about 6 screws in it. Remove those screws, and you'll find a paper thin rubber diaphram and a spring. Replace that diaphram, ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...carb will have a pump diaphram, this is actuated by a positive and negative pulse from the piston riseing and falling ( there will either be an impulse pipe from the crankcase to the carb, or a hole ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...followed by the gasket, on the metering side the diaphram has a metal disc and a gasket, on this side the gasket goes against the carb body followed by the diaphram ( the gasket is used as a spacer
Usually answered in minutes!
103 Questions
38 Questions
14 Questions
13 Questions
14 Questions