Questions & Answers for: car struggles start dies acceleration

97 legacy gtb twinturbo. engine died within 1km dead! Today my 97 legacy gtb just cut out, sounded like not getting enough fuel. when i pushed the accelerator down it just lurched and jumped ...

...car starts and idle's just fine. When I go to accelerate from a stop it struggles and sputters through first gear and once I get to about 15mph, or it shifts, everything seems to be ok. Occasionally ...

...start up just fine with no problems. but she struggles to accelerate. sometimes if i rev the engine or give her alot of gas she will run fine. now its a constant problem and she wants to die while ...

car starts fine. but when idling the RPM's fluxuate and it struggles. The RPM's also fluxuate at running speeds. When I hit the accelerator the engine chokes, problem varies on severity day to

start blinking. Then you feel the pathfinder struggling to accelerate and then slowly dies and does not turn back on. Then we charge the battery and it works fine until the battery gets drained again.

Car struggles to start from cold; when it starts, it immediately dies out again. I had my car serviced 3 weeks ago and it has since been extremely sluggish. Now if I try to start it on a cold morning,

...car is struggling also have to put it into neutral to start or it will just start & die but in neutral stays started usually How long since a tune-up? Are there any applicable trouble codes? Some of ...

...came up. I had just filled up in Loreto, after driving for about 30 miles I was following a slow car down a hill. My foot was off the accelerator. At the bottom of the hill when I went to ...

...Car was running fine when it started to seem to struggle to get fuel..would pull forward in quick bumps Common signs of a weak pump would be slow acceleration, hard starting, dying at stop ...

...struggles when it does come to a start i have to floor the acceleration then it dies There is air in the fuel system. I normally bleed the engine via the injector youl need to open injector 1 then ...