...start fine from that point on. a friend suggested that the fuel tank might not be venting correctly. would that stop the car from starting? have the crank shaft sensor checked out when was the last ...
Question about 2002 Explorer
a chip inside your key to start the car . Your car wont start because you are using the wrong key, your ignition is no longer able to read the key (ignition replacement), or your key is malfunctioning
...CAR WOULD START EVERYTIME. I BROUGHT THE CAR HOME AND READ ALL I COULD ON THIS PROBLEM. IT WAS THE IGNITION RELAY $7 TO $15 AT ANY PART STORE. IN THE MAIN POWER BOX ON THE DRIVER SIDE NEAR THE FIRE ...
...start the car, if the battery do not hold a charge then replace it, anything below 11.5 v is bad for the electronics, remember that the starter pulls close to 200A when starting the car, so turn off ...
car will not start When I turn the key to start the car, it makes a noise but does not start up! 1.) check your battery,, 2.) check that your fuel pump is working.,.
start the car. Do you notice any spark. Actually you should see. If in case there is no spark then it's a spark plug problem. Also the coil pack gives power to spark plug. So check the voltage at coil
Question about 2001 Explorer
start. SOme times smells like something is burning while driving. Please tell me what it could be. This is happening to much.d Car not starting or turning over indicates towards multiple possibilities
Question about 2002 Explorer
start car does not start wait about 5 or ten mintues car did start did this three differnt times last time did not start at all towed to repair shop next day car started after sitting all night he has
Question about 1999 Explorer
...car not to start One guy mentioned carb cleaner. I would use starting fluid due to the fact that if it is a fuel problem the car will run for a few seconds on starting fluid. If it won't run on ...
Question about 2004 Explorer
car starts very rough and will not stay running now. Had to change battery because it died and would not get a jump start. Then it started and runs rough and will not stay on. use a scan tool to reset
Usually answered in minutes!
2,998 Questions
2,307 Questions
2,248 Questions
2,302 Questions
1,513 Questions