Questions & Answers for: how to use a car jack

Question about 1993 Colt Vista

1 Answer

...jack I got the car with no manual and can,t find the jack or jack handle. I did find the spare jack is under the front passenger seat- wrench and jack handle are under the carpet in the rear of the ...

Ad

Question about 2004 Tiburon

1 Answer

car from the front tow hook, place your axle stands under the front jack points, then let the car down onto the axle stands. Always use axle stands when working on your car, never trust the jack alone

Ad

car high enough if you jack at a frame rail. Jacking on the transaxle housing puts you at high risk of doing some very expensive damage. That housing is either aluminum or white metal. They don't bend

...jack car so you will have to screw thethread anticlockwise to lower/reduce jacks height and it will come loose and then come out of its fitting always refit jack as to above hope this helps ? best ...

JACK FROM WALMART COMES IN A NICE PLASTIC CASE FITS RIGHT IN YOUR TRUNK AND ITS LIGHT WEIGHT OR YOU CAN GO TO YOUR LOCAL AUTO SALVAGE AND GET A FACTORY JACK OUT OF A WRECKED CAR ( SAME CAR AS YOU HAVE

...car jack. The bottom of the tire should visibly measure eight to nine inches from the ground. 4)  Position a jack stand slightly left of the car jack. Remove the locking pin from the support arm ...

Question about 1987 Golf

1 Answer

jack for the car has a groove that the reinforced jack points fit into. The original jack is a Y type but an ordinary scissor jack with the correct groove in the lift point would also work. Attempting

Question about 1999 Boxster

1 Answer

On one jack stand. Problems How to put on jack stands Jack the car up, insert the jack stand and lower the car. Only put jack stands on one side of the car at a time.

...jack the car up, use jack stands, then using your jack and a piece of 2x4 wood between the jack and the engine block raise the jack until you just touch the engine. then loosen the motor mount bolts, ...

...jack up car, fit safety jacks at each side of frame well in front of rear wheels, remove tail shaft , place floor jack under rear axle housing and jack up , but not lifting off safety jacks.remove ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...