Questions & Answers for: Goodman cap safety valve turn

Question about GMS90703BXA Heater

2 Answers

...valve should click and the burners will ignite. There is a safety switch that will sense flame and then keep the gas going to the burners. If it does not sense it, it will shut it off within 10 ...

Ad

Question about GMS90703BXA Heater

1 Answer

...valve shuts down as a safety precaution. After 3 tries, the furnace will go into "lockout" and will not let it attempt to start again. The lockout can be resolved by turning off the power to the ...

Ad

valve (24 volts). Either a pilot will come on or the burner tube will ignite then spread the flame to all burners. Lastly a safety sensor will be looking for a certain temperature within a few seconds

...cap) may be required. Good luck and let me know if this helps. On a call for heat, the 24 volt thermostat sends a signal to the control module. The control module will indicate a call for heat with a ...

Question about GMS90703BXA Heater

1 Answer

...try to take the cap loose on the drip leg of the gas pipe and make sure you have gas to the furnace. If the igniter glows but shuts off, usually mean there is a problem with gas valve or vent ...

Question about GMS90703BXA Heater

1 Answer

valve (24 volts). Either a pilot will come on or the burner tube will ignite then spread the flame to all burners. Lastly a safety sensor will be looking for a certain temperature within a few seconds

Question about GMS90703BXA Heater

2 Answers

...valve as the ignore glows. You will be looking for 24 volts AC. If you get none, check for a safety device called a roll out switch. There may be more than one and they are located either right or ...

Question about GMS90703BXA Heater

1 Answer

valve (24 volts). Either a pilot will come on or the burner tube will ignite then spread the flame to all burners. Lastly a safety sensor will be looking for a certain temperature within a few seconds

cap off the gas valve it looks like a large flat head slot screw remove the metal cap you will see a white plastic cap under the metal cap. we are going to be adjusting it out counter clockwise 1/8 of

Question about GMS90703BXA Heater

1 Answer

valve turns on if all limit switches and inducer switch are closed;.4 flame sensor checks for flame.after short delay fan comes on.if any safety switch is open theres no heat.look in little window and

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Goodman Heating and Cooling Experts

Paul Carew

Level 3 Expert

3808 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

Are you a Goodman Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...